October WIP: Save the Castle!

[theprairiefox]

Here is my final. My intaglio plate did not cooperate, so I had to finish it digitally. I will try again. I really want to get my intaglio plates working from the GlowForge!

[braden H]

@theprairiefox Nice! I get a one panel comic vibe (kinda like the far side ) from this one with the thick border. It almost needs a hilarious caption underneath.

I like how the doctor's hair kinda resembles brains!

I can't think of anything to add at this point. Too bad you couldn't get the glow forge to cooperate.

[TessaW]

Yay! I love this concept. It's nice to see what you come up with from a printmaking perspective.

[theprairiefox]

@Braden-Hallett yeah, I haven't pulled an intaglio print off with it yet... just got to keep experimenting. I used an acrylic plate this time, but I think the engraving was too deep to get it to work.

I am going to cut a shallower plate and see if I can pull it off. If it works I will post a copy.

[theprairiefox]

@TessaW well, I finally got to see the master printmaker I have been learning from and we got an intaglio print to work that was cut from the GlowForge! So wish I could have submitted this one instead of the digital finish. It is so much richer...

[braden H]

@theprairiefox Damn that looks super nice! 'Richer' is definitely a good word for it

[TessaW]

@theprairiefox That's awesome! I'm glad you were able to get an intaglio print out of it. You were really successful in getting the digital version to have a traditional grit to it, but this latest version really has that richness you mention.

[NicolaSchofield]

@theprairiefox I don't know what an intaglio print is but this looks almost embossed? - I would want to run my fingers over the lines!

[theprairiefox]

@neschof Intaglio is used to describe lots of different types of printing; drypoint, etchings, and aquatints are examples. It basically means you use a wet piece of paper and the ink is down in the lines on the plate. The press pushes the paper into the plate to pick up the ink.

Relief printing is the other kind (linoleum cut, woodcut, wood engraving) in that type of printing the ink is on the top surface of the plate and paper only picks up that part of the print.

I really like intaglio because of the "plate tone" the shadows and the 'richness' you get from wiping the plate to varying degrees.

Quite often the paper will come out 'embossed' as it will take the shape of the plate as well.

[NicolaSchofield]

@theprairiefox Thank you for the detailed explanation - I've done a tiny bit of lino cutting in the past but never this type of printing - fascinating!